Differences

This shows you the differences between two versions of the page.

--- harddrive_setup [2011/04/09 18:59] – 192.168.2.30
+++ harddrive_setup [2021/02/01 05:55] (current) – external edit 127.0.0.1
@@ Line 28: / Line 28: @@
   * Make it read/write
- mdadm --readwrite /dev/md/md0
+  mdadm --readwrite /dev/md/md0
+  * Update /etc/mdadm/mdadm.conf
+  mdadm --examine --scan >> /etc/mdadm/mdadm.conf
+  * Create an LVM2 logical block device on top of this RAID:
+  pvcreate /dev/md/md0
+  vgcreate test /dev/md/md0
+  lvcreate -l 100%VG -n root test
+  * Create a dm-crypt on top of the LVM:
+  modprobe sha512_generic
+  modprobe aes_generic
+  modprobe aes-x86_64
+  cryptsetup -y luksFormat /dev/test/root -c aes-xts-plain64 -s 512
+  * Activate dm-crypt:
+  cryptsetup luksOpen /dev/mapper/test-root test-root_crypt
+  * Create ext4 partition:
+  mkfs.ext4 /dev/mapper/test-root_crypt
+In this moment the disk is ready for installing software on it. What I'm trying to do is to copy my old harddrive installation into this new system. I will probably copy this using rsync, but first I want to check if the ext4 filesystem can be seen by grub2. I plan to test this from the grub console on my currently running system.
+===== Important commands =====
+blkid - lists uuids of block devices, could be useful for configuring grub.
+grub-mkdevicemap - could be necessary if you add more harddrives and want to install grub in the new harddrives.
-  * Create an LVM2 logical block device for the system ("/")