Differences

This shows you the differences between two versions of the page.

--- harddrive_setup [2011/04/09 18:03] – 192.168.2.30
+++ harddrive_setup [2012/06/18 00:40] – memeruiz
@@ Line 6: / Line 6: @@
 The rest of the disk is the whole linux system (including /boot). This is going to be a RAID1 (copy) with a LVM on top (to allow future extension) and encryption on top.
-  * Create GPT partition table with gdisk
+In each harddrive do the following:
+  * Create GPT partition table with gdisk. (Check that the alignment is to 2048-sectors for 4Kb harddrives, if not set it like that)
   * Create a BIOS boot partition of 1MB (necessary for grub2 on GPT disks)
-  * Create a swap partition
+  * Create a Linux swap partition (2G)
+  * Create a Linux RAID partition (the rest of space)
+Now in the first harddrive do:
+  * Create the Linux RAID1 device:
+  mdadm --create md0 --level=1 --raid-devices=2 -R /dev/sdf3 missing
+  * Replace "missing" for your second drive if its already connected.
+  * For some reason the drive is read only still:
+  md0 : active (auto-read-only) raid1 sdf3[0]
+        ?????? blocks super 1.2 [2/1] [U_]
+  * Make it read/write
+  mdadm --readwrite /dev/md/md0
+  * Update /etc/mdadm/mdadm.conf
+  mdadm --examine --scan >> /etc/mdadm/mdadm.conf
+  * Create an LVM2 logical block device on top of this RAID:
+  pvcreate /dev/md/md0
+  vgcreate test /dev/md/md0
+  lvcreate -l 100%VG -n root test
+  * Create a dm-crypt on top of the LVM:
+  modprobe sha512_generic
+  modprobe aes_generic
+  modprobe aes-x86_64
+  cryptsetup -y luksFormat /dev/test/root -c aes-xts-plain64 -s 512
+  * Activate dm-crypt:
+  cryptsetup luksOpen /dev/mapper/test-root test-root_crypt
+  * Create ext4 partition:
+  mkfs.ext4 /dev/mapper/test-root_crypt
+In this moment the disk is ready for installing software on it. What I'm trying to do is to copy my old harddrive installation into this new system. I will probably copy this using rsync, but first I want to check if the ext4 filesystem can be seen by grub2. I plan to test this from the grub console on my currently running system.
+===== Important commands =====
+blkid - lists uuids of block devices, could be useful for configuring grub.
+grub-mkdevicemap - could be necessary if you add more harddrives and want to install grub in the new harddrives.