multiwiicopter
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
multiwiicopter [2012/01/27 15:41] – memeruiz | multiwiicopter [2012/01/27 21:03] – memeruiz | ||
---|---|---|---|
Line 72: | Line 72: | ||
http:// | http:// | ||
+ | ===== Programming/ | ||
+ | |||
+ | The multiwiicopter uses an arduino as the FC unit. You can program this board from debian by installing arduino package. You get version 1.0 with a relatively new gcc-avr. You have three ways to program the arduino pro mini: | ||
+ | |||
+ | - From arduino sketch, using upload function. | ||
+ | - From arduino sketch, using upload with avrdude function. | ||
+ | - Connecting an avr isp to the spi pins of the board (this may interfere with other electronics on the multiwiicopter, | ||
+ | |||
+ | In 1 and 2 you only need to specify the port device to program the arduino. In 3 you need to solder four wires and use an avr isp programmer board. Options 1 and 2 work fine with multiwiicopter. Version 3 is only necessary if more flash is needed and bootloader can be erased. | ||
+ | |||
+ | To read the flash/ | ||
+ | |||
+ | avrdude.exe -C ..\etc\avrdude.conf -pm328p -cstk500 -PCOM2 -b115200 -v -Ueeprom: | ||
+ | |||
+ | http:// | ||
multiwiicopter.txt · Last modified: 2021/02/01 05:55 by 127.0.0.1