lpc43xx_freedev
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| lpc43xx_freedev [2012/03/05 07:18] – memeruiz | lpc43xx_freedev [2021/02/01 05:55] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| Some notes to make a development board for the lpc4357 microcontroller. | Some notes to make a development board for the lpc4357 microcontroller. | ||
| + | Design steps: | ||
| + | |||
| + | * Add Processor crystal and RTC crystal | ||
| + | * Add programming ports: JTAG, USART0, and ISP | ||
| * Leave some jumpers or dip switch for the boot pins: P2_9, P2_8, P1_2, P1_1. | * Leave some jumpers or dip switch for the boot pins: P2_9, P2_8, P1_2, P1_1. | ||
| - | * Serial flash. 4 bit bidirectional | + | * Serial flash. |
| * USB2.0 OTG | * USB2.0 OTG | ||
| + | * USB1 Prt | ||
| * Ethernet | * Ethernet | ||
| - | | + | * VBAT jumper |
| - | | + | * USB0 external oscillator is necessary? |
| - | * USB0 external oscillator is necessary. | + | |
| * Reset switch. | * Reset switch. | ||
| + | |||
| + | ===== JTAG ===== | ||
| + | |||
| + | DBGEN can be 0 for disabling brakepoints. Put a solder jumper there. http:// | ||
| + | |||
| + | http:// | ||
| + | |||
| + | http:// | ||
| + | |||
| + | |||
| + | http:// | ||
| + | |||
| + | |||
| + | ===== MISC ===== | ||
| + | |||
| + | |||
| PHY: http:// | PHY: http:// | ||
| Line 30: | Line 50: | ||
| http:// | http:// | ||
| + | http:// | ||
| + | |||
| + | http:// | ||
| + | |||
| + | http:// | ||
| + | |||
| + | http:// | ||
| + | |||
| + | http:// | ||
| + | |||
| + | lpc21xx board reference design: http:// | ||
| + | |||
| + | lpc21xx linux http:// | ||
| + | |||
| + | isp : http:// | ||
| + | |||
| + | tarjetas de desarrollo con LPCs: http:// | ||
| + | |||
| + | JTAG explanation: | ||
lpc43xx_freedev.1330931883.txt.gz · Last modified: 2021/02/01 05:55 (external edit)
